CLI Command

Host and System Control  

Power on the server

start /SYS

Power off the server

stop [-force] /SYS

Power cycle the server

reset /SYS

Redirect host console stream to Oracle ILOM

start /HOST/console

Enable SPARC diagnostic state (default value)

set /SYS keyswitch_state=diag

Oracle ILOM Initial Setup  

Show network configuration
show /SP/network/

Configure static IPv4 address
set /SP/network pendingipdiscovery=static pendingipaddress= address pendingipnetmask=netmask pendingipgateway=address commitpending=true 

Create user account with all privileges 

create /SP/users/newusername role=aucro [password=password]

Create user account with operator privileges
create /SP/users/newusername role=cro [password=password]

Create read-only user account
create /SP/users/newusername role=o[password=password]

Delete user account
delete /SP/users/username

System Monitoring and Status 

Show the Oracle ILOM Event Log
show /SP/logs/event/list

List all hardware faults
show -level all -output table /SP/faultmgmt

List all temperature sensor readings
show -level all -output table /SYS type==Temperature value

Show actual system power consumption
show /SP/VPS value

System Inventory

List all DIMMs
show -level all -output table /SYS type==DIMM

Lista all CPUs
show -level all -output table /SYS type=='Host Processor'

List all power supplies
show -level all -output table /SYS type=='Power Supply' fru_name==*

List all hard disks
show -l all /SYS type=='Hard Disk'

Oracle ILOM Maintenance

Update Oracle ILOM firmware
load -source URI /SP/firmware

Reset Oracle ILOM SP
reset /SP

Oracle ILOM Configuration Management

Reset Oracle ILOM configuration to factory defaults
set /SP reset_to_defaults=all

Backup Oracle ILOM configuration to a file
dump -destination URI /SP/config

Restore Oracle ILOM configuration from a file
load -source URI /SP/config